Filter by moving average
The filter P. s. median allows direction by price position relative to the median. In normal mode, a lower-middle allowed long, higher than shorts; the field Revers? changes sides.
Add a filter to the task
Open up the task of creating or editing a Binance robot or a Bybit robot. — The Bybit robot In the filter block, select the middle of the second.
Field Active is missing. Set the filter for the pair the task is going to work with.
Set the calculation
The TF sets the time frame for the calculation. The initial value is 1 minute.
The Type of candles is either normal or Heiken-Ash. By default, ordinary candles are used.
Type SMA, EMA, Wilders Moving Average, VWMA or Sr. line MRC (FOMO). The new form is SMA.
Period from 5 to 200 bars, by default 100. For the mean line MRC (FOMO), you need the value 200.
Count by the last price or the entire bar range. By default Last price
When the filter allows action
Last price: price below average allows long, price at average or above shorts.
The entire bar range: the bar is completely below the middle, allowing a long, completely above the shorts. If the bar range is in or across the middle, no direction is allowed.
It's a current status check on the line. No new crossing is required to meet the conditions.
Determine the meaning of the parameters
SMA, EMA, and Wilders Moving Average differ in how they smooth the price; VWMA takes the volume into account. The MRC (FOMO) variant uses the middle line of its channel. After the change of type, check the period and the result on the chart.
The directions rules above are for the deactivated Reverse field? is the initial state of the form. If you turn it on, the permissions for the long and short change places. The conditions of both directions and the same direction will remain the same.
Set the action when you exit the filter
Field When the filter is out refers to the situation when the task stops passing this condition. The new card has the Cancel Cycles option. The form also includes Sell by market and Sell by market with deviation (if indicated).
The filter can also affect a task that is already working: the exit from the condition transmits the selected command. Before you save, check the command's implications for your robot in the Binance or Bybit task description. — Binance tasks — Bybit tasks
Save and verify the task
Save the filter card, then check the rest of the conditions and parameters. Several filters should allow it to move at the same time. The filtering permission itself does not mean that the order has been sent or executed.
If the task mode supports the task without a basic signal, the filters can be involved in its start. So the conditions and the action you choose to take when you exit them should be checked before the robot starts.