Filter by MRC (FOMO)
The filter From MRC (FOMO) checks the price position with respect to the MRC channel. The selected stripes, filter type and bar checking method together determine the direction of travel.
Add a filter to the task
Open up the task of creating or editing a Binance robot or a Bybit robot. — The Bybit robot In the filter block, select MRC (FOMO).
Field Active is missing. Set the filter for the pair the task is going to work with.
Set the calculation
The TF sets the time frame for the calculation. The initial value is 1 minute.
The Type of candles is either normal or Heiken-Ash. By default, ordinary candles are used.
The Type of filter determines the directional rule. The new form has the default option By default; the available options are broken down below.
Overbought/Overbought Slable, Middle or Strong. The choice changes the pair of external channel stripes; in the new form Slabo is selected.
Slide right from 0 to 200 bars, default 0. When the current price is shifted, the channel of the earlier bar is compared.
Count by the last price or the entire bar range. By default Last price
The MRC calculation period in this filter is fixed: 200 bars. There's no separate field to change it.
When the filter allows action
By default: the last price on the upper or upper strip is allowed, the lower or lower long, inside both directions. The bar's range is the upper band's touch, the lower long; the bar that touches both bands, does not allow any direction. The bar is all inside and it's both.
Inland: Both directions are allowed only when the price is strictly within the channel. When you're calculating the range, the entire bar should be inside. The band's not gonna pass.
On the inner channel from the middle line: the lower half of the channel allows a long, the upper short. The price or the entire bar must be between the middle and the corresponding outer band; no border contact passes.
Above/Beyond the channel: the price is much higher than the top band, allowing for shorts, much lower than the bottom long. For the bar range, the entire bar must be behind the appropriate band.
By past signal (Trend): the last touch of the lower band or exit below it allows a long; the last touch of the upper or exit above shorts. The direction is maintained until the next such event in computational history.
Determine the meaning of the parameters
In the On the previous signal mode, when calculating the bar range that touched both bands, it is taken into account as an event at the bottom band. When the reverse is turned off, it'll allow the long.
The names Sweat, Middle and Strong denote the selected channel bands. They don't evaluate the quality of the signal and they don't promise the outcome of the trade. In the past signal mode without an appropriate event in the computational history, no direction is allowed.
The directions rules above are for the deactivated Reverse field? is the initial state of the form. If you turn it on, the permissions for the long and short change places. The conditions of both directions and the same direction will remain the same.
Set the action when you exit the filter
Field When the filter is out refers to the situation when the task stops passing this condition. The new card has the Cancel Cycles option. The form also includes Sell by market and Sell by market with deviation (if indicated).
The filter can also affect a task that is already working: the exit from the condition transmits the selected command. Before you save, check the command's implications for your robot in the Binance or Bybit task description. — Binance tasks — Bybit tasks
Save and verify the task
Save the filter card, then check the rest of the conditions and parameters. Several filters should allow it to move at the same time. The filtering permission itself does not mean that the order has been sent or executed.
If the task mode supports the task without a basic signal, the filters can be involved in its start. So the conditions and the action you choose to take when you exit them should be checked before the robot starts.