Vortex filter

The filter By VORTEX compares lines VI+ and VI−. It allows direction by their current ratio.

Add a filter to the task

Open up the task of creating or editing a Binance robot or a Bybit robot. — The Bybit robot In the filter block, select VORTEX.

Field Active is missing. Set the filter for the pair the task is going to work with.

Set the calculation

• The TF sets the time frame for the calculation. The initial value is 1 minute.

• The Type of candles is either normal or Heiken-Ash. By default, ordinary candles are used.

• Calculation On closing the bar or On crossing (every second). The first uses closed bars, the second takes into account the current unopened bar. In the new form, the mode P is selected (every second).

• Period from 2 to 50 bars. The starting value is 14.

When the filter allows action

• VI+ above VI− is the allowed long.

• VI+ below VI− or equal to it is allowed short.

• New line intersections are not a separate requirement of this filter.

Determine the meaning of the parameters

When you turn on the reverse, the sides change places. The line equation also goes to the opposite side; it doesn't mean the two directions are allowed.

The directions rules above are for the deactivated Reverse field? is the initial state of the form. If you turn it on, the permissions for the long and short change places. The conditions of both directions and the same direction will remain the same.

Set the action when you exit the filter

Field When the filter is out refers to the situation when the task stops passing this condition. The new card has the Cancel Cycles option. The form also includes Sell by market and Sell by market with deviation (if indicated).

The filter can also affect a task that is already working: the exit from the condition transmits the selected command. Before you save, check the command's implications for your robot in the Binance or Bybit task description. — Binance tasks — Bybit tasks

Save and verify the task

Save the filter card, then check the rest of the conditions and parameters. Several filters should allow it to move at the same time. The filtering permission itself does not mean that the order has been sent or executed.

If the task mode supports the task without a basic signal, the filters can be involved in its start. So the conditions and the action you choose to take when you exit them should be checked before the robot starts.